What Does When Ethylene Oxide Processed Color of Dot Turns Blue Mean
POTENTIAL HAZARDS
HEALTH
· TOXIC; may be fatal if inhaled or absorbed through skin. Some may cause severe skin burns and eye damage.
· Contact with gas or liquefied gas may cause burns, severe injury and/or frostbite.
· Fire will produce irritating, corrosive and/or toxic gases.
· Runoff from fire control or dilution water may cause environmental contamination.
FIRE OR EXPLOSION
· Flammable; may be ignited by heat, sparks or flames.
· May form explosive mixtures with air. Ethylene oxide (UN1040) may react explosively even in the absence of air.
· Those substances designated with a (P) may polymerize explosively when heated or involved in a fire.
· Vapors from liquefied gas are initially heavier than air and spread along ground.
· Vapors may travel to source of ignition and flash back.
· Some of these materials may react violently with water.
· Cylinders exposed to fire may vent and release toxic and flammable gas through pressure relief devices.
· Containers may explode when heated.
· Ruptured cylinders may rocket.
· Runoff may create fire or explosion hazard.
PUBLIC SAFETY
· CALL 911. Then call emergency response telephone number on shipping paper. If shipping paper not available or no answer, refer to appropriate telephone number listed on the inside back cover.
· Keep unauthorized personnel away.
· Stay upwind, uphill and/or upstream.
· Many gases are heavier than air and will spread along the ground and collect in low or confined areas (sewers, basements, tanks, etc.).
· Ventilate closed spaces before entering, but only if properly trained and equipped.
PROTECTIVE CLOTHING
· Wear positive pressure self-contained breathing apparatus (SCBA).
· Wear chemical protective clothing that is specifically recommended by the manufacturer when there is NO RISK OF FIRE.
· Structural firefighters' protective clothing provides thermal protection but only limited chemical protection.
EVACUATION
Immediate precautionary measure
· Isolate spill or leak area for at least 100 meters (330 feet) in all directions.
Spill
· For highlighted materials: see Table 1 - .
· For non-highlighted materials: increase the immediate precautionary measure distance, in the downwind direction, as necessary.
Fire
· If tank, rail car or tank truck is involved in a fire, ISOLATE for 1600 meters (1 mile) in all directions; also, consider initial evacuation for 1600 meters (1 mile) in all directions.
![]() | In Canada, an Emergency Response Assistance Plan (ERAP) may be required for this product. Please consult the shipping paper and/or the ERAP Program Section. |
EMERGENCY RESPONSE
FIRE
· DO NOT EXTINGUISH A LEAKING GAS FIRE UNLESS LEAK CAN BE STOPPED.
Small Fire
· Dry chemical, CO2, water spray or alcohol-resistant foam.
Large Fire
· Water spray, fog or alcohol-resistant foam.
· FOR CHLOROSILANES, DO NOT USE WATER; use AFFF alcohol-resistant medium-expansion foam.
· If it can be done safely, move undamaged containers away from the area around the fire.
· Damaged cylinders should be handled only by specialists.
Fire Involving Tanks
· Fight fire from maximum distance or use unmanned master stream devices or monitor nozzles.
· Cool containers with flooding quantities of water until well after fire is out.
· Do not direct water at source of leak or safety devices; icing may occur.
· Withdraw immediately in case of rising sound from venting safety devices or discoloration of tank.
· ALWAYS stay away from tanks engulfed in fire.
SPILL OR LEAK
· ELIMINATE all ignition sources (no smoking, flares, sparks or flames) from immediate area.
· All equipment used when handling the product must be grounded.
· Do not touch or walk through spilled material.
· Stop leak if you can do it without risk.
· Do not direct water at spill or source of leak.
· Use water spray to reduce vapors or divert vapor cloud drift. Avoid allowing water runoff to contact spilled material.
· FOR CHLOROSILANES, use AFFF alcohol-resistant medium-expansion foam to reduce vapors.
· If possible, turn leaking containers so that gas escapes rather than liquid.
· Prevent entry into waterways, sewers, basements or confined areas.
· Isolate area until gas has dispersed.
FIRST AID
· Call 911 or emergency medical service.
· Ensure that medical personnel are aware of the material(s) involved and take precautions to protect themselves.
· Move victim to fresh air if it can be done safely.
· Give artificial respiration if victim is not breathing.
· Do not perform mouth-to-mouth resuscitation if victim ingested or inhaled the substance; wash face and mouth before giving artificial respiration. Use a pocket mask equipped with a one-way valve or other proper respiratory medical device.
· Administer oxygen if breathing is difficult.
· Remove and isolate contaminated clothing and shoes.
· In case of contact with substance, immediately flush skin or eyes with running water for at least 20 minutes.
· In case of contact with liquefied gas, thaw frosted parts with lukewarm water.
· In case of burns, immediately cool affected skin for as long as possible with cold water. Do not remove clothing if adhering to skin.
· Keep victim calm and warm.
· Keep victim under observation.
· Effects of contact or inhalation may be delayed.
Source: https://webwiser.nlm.nih.gov/WebWISER/substance?substanceId=52&identifier=Ethylene%20Oxide&identifierType=name&catId=54
0 Response to "What Does When Ethylene Oxide Processed Color of Dot Turns Blue Mean"
ارسال یک نظر